[Matteo, Eleonora]
We reinstalled the second ADC PCie into the standalone after it was taken out because of the timing-box issue.
The standalone PCie slots are piled up in vertical are (from the bottom):
1) ADC1
2) ADC2
3) DAC
4) empty
We connected the new timing box to ADC2 and the real time model was restarted without problems.
We installed one of the two new BNC2dsub box in the clean room (to be used for AA signals) and we connected the cables from to the AA module which is in the standalone rack.
Now the situation is:
ADC0
-16 channel in the standalone rack (used for local control)
-16 channel in the clean room. (4 used for FC lock signals, 12 available for AA)
ADC1
-16 channel in the clean room. (available for AA)
-16 channel possibly available by installing an additional BNC2dsub box
Now we need to test if ADC2 can correctely acquire signals. I need to modify the real time model to do this.
Pic1: modules on the standalone rack in the corner of TAMA central area
Pic2: modules on the rack in the clean room