Remote control of the 290m target

Today I finished the setting for remote controlling the 2nd target.

First thing is to turn the target into the remote mode, since on the label there are only two modes(remote and local), but actually when you try to move the handle, there are three levels.Remote is the one on the left.

I connected the power control box of the target (1st picture) to the '133.40.121.***'port, so when you want to control the target, you need connect to the laptop to the same IP address.

The first thing is to set the IP address and the netmask of your own laptop to 192.168.10.2 and 255.255.255.0.

Then go the address 192.168.10.1, you will see the webpage in pic 2. Enter your username(admin) and the password(magic). The next page (pic 3)shows the condition of every outlet now.

Then press the button on the left side with the red rectangle out of it, you will enter the page where you can control the power in and out.(pic 4)

Every column in the chart means:

1st: The number of the port which written on the top of the control box, from right to left is from 1 to 4.
2nd: The name of the outlet, this depend on the order you plug in everything, for now we did like what shows in the picture.
3rd: This column is used to control the power, the three buttons in each row are "power on","power off" and "reboot".
4th: The condition of the power supply now.